Skip to content
English
Submit a Support Ticket Sign in
Online Training Portal
  • There are no suggestions because the search field is empty.

Workpack Release Notes - 06/04/2025

RELEASE NOTES

Wall Thickness

  • Now all detected walls are automatically assigned one of detected wall thicknesses. By default, walls are displayed in the old way, without different thickness values.

chrome_NnyvcLkF0d

Filters

  • A new Wall Thickness toggle has been added under the Other tab in Filters.
    • Off (default): walls are classified by type only (thin ≈ interior, thick ≈ exterior).
    • On: each wall’s detected thickness is shown.

Properties Panel

  • Individual Walls: thickness value is displayed.
  • Wall Groups: all detected thicknesses within a group are listed (walls are not pre-grouped by thickness).

Manually Added Walls and Groups

  • Walls added manually (bypassing detection) default to a nominal thickness but are displayed as 0 ft until re-measured.
  • Newly created, empty wall groups default to 0 ft thickness.

Lock User on Page When Setting Up Takeoff Zones

  • Users are now “locked” to the drawing page until auto takeoff zone setup is completed or canceled.
  • This prevents accidental navigation away from the current drawing while configuring takeoff zones.

chrome_CoAYi7BpKi

Auto-Exit Add Mode After Setting Label Template

  • Upon placing any label-template object (Wall, Door, Window, Room, Custom Label, or Keynote), the tool now automatically exits Add Mode.
  • Eliminates the extra step of manually turning off Add Mode after each label placement.

chrome_UWoYBvrcJ4

Convert Any Area to Any Area

  • The 'Convert Area' tool is now universal across all area types (Rooms, Gross Areas, Area Measurements, and Area Patterns), allowing seamless conversion between any two.

chrome_plDClWfMG5

Rename “Column Schedule” to “Beams” and “Framings” to “Lines” in Processing Confirmation

  • In Processing Confirmation, the Column Schedule checkbox is now labeled Beams, and Framings is relabeled Lines.
  • Terminology updated to better reflect detection results.

image (110)

Disable Add Mode When Starting Takeoff Zone Autodetection

  • Add Mode now isn’t activated when Takeoff Zone Autodetection starts both in Takeoff and AI-Setup modes.
  • Prevents mixing manual zone creation with automated detection, ensuring a cleaner workflow.

chrome_WNj1wR1uqs